Just print them out and glue or tape them to a sheet of MDF and cut/drill away. The good news you don’t have to do any of this, as you don’t have to do any of this, because I put everything into SketchUp and Adobe Illustrator and created an awesome set of Tabletop Arcade Plans you can use to make quick work of this. This way I could make sure I didn’t do something dumb like put the buttons where the walls were! ![]() The thick outer lines are simply a reference I used for the cabinet walls underneath. This took a bit of time to get everything sorted out where it would feel comfortable to play and still meet my strict size requirements (smaller the better!). ![]() Next up I laid out the components on the MDF and came up with the mounting locations for the LCD, joystick and buttons. After that, I just went around the bezel with a razor knife and removed any remaining gunk. Once you get it all removed the LCD panel will simply lift up from the bezel. Just use a few different sizes of flat tip screwdrivers and slowly work around the edges of the LCD panel scraping away the glue. It was surprisingly easy to do! This is great because I wanted this to be a simple project anyone could do. All it took was a couple of flat tip screwdrivers and a little scraping. The good news is, removing the glue actually turned out to be super easy. If you bought the same monitor for your arcade, you should have four boards (still wired together). They’ll get added to the inside of our cabinet in just a bit. This requires just removing three screws and then using a couple of screwdrivers to pop it open by going around the bezel.Īfter that, I just unscrewed and removed all of the components inside the monitor. ![]() So first things first, I removed the back cover. I need my tabletop arcade to be somewhat affordable after all! The second thing I discovered is that simply buying the LCD panel is two to three times the price of buying a monitor and just gutting it! Ridiculous. However, I then did some research and found out that this is a new trend in monitor construction and it might be difficult to find a monitor that was not glued in. When I opened the case of the monitor I was very disappointed at what I saw. When I originally spec’d and bought this monitor, it never occurred to me that LCD panels would be glued into the bezel. If you’d like to build this project yourself, here’s a handy parts list to get you started:Īnd here are some of the tools I used in this project:
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |